Allenheath GS1 USER GUIDE Manuel d'utilisateur télécharger pdf (Page 7)

HANNEL AUX SENDS

There are five Aux busses on the GS1. These are typically used for sending

channel signals to common FX such as reverbs and delays. Auxs 2-5 are always

post fade. Aux sends 4 & 5 are accessed by pressing the Channel Aux send select

switch.

ASTER AUX SENDS

Aux 1 can be switched at the master section to be pre fade. A pre fade Aux is

commonly used for foldback or cue for a musicians headphone mix where the

monitor signal is not affected by channel fader. In most cases foldback will be

required from the tape returns, When Aux 1 is switched to pre, it selects the TAPE

RTN signal path from the mono channel strips.

AUX

GS1

NOTES

CHANNEL SENDS MASTER AUX SENDS

AUX (post)

CUE (pre)

Auxiliaries

-14 14

-14

Auxiliary Sends

3/5

to Aux 2 & 3

to Aux 4 & 5

2/4

SECTION 2 SIGNAL PATHS

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Pas de commentaire

Allenheath GS1 USER GUIDE Manuel d'utilisateur Page 7